Clearcoats

#555 UNIVERSAL QUICK FINISH
CLEARCOAT 4.2 VOC (NR)

PRODUCT DESCRIPTION:
ADVANTAGE #555 UNIVERSAL QUICK FINISH Clearcoat 4.2 VOC was designed to offer ease of application, great flow and leveling, superior gloss & DOI in a highly productive 2K polyurethane clearcoat. Under the proper conditions #555 can be polished in as little as 90 minutes.

SURFACE PREPARATION:
Apply Undercoats and Basecoat per manufacturer’s instruction. Over OEM or completely cured previously painted substrates scuff with a gray scuff pad or 600 grit then wipe clean with Wax & Grease Remover. Allow basecoat adequate flash time (follow manufacturer’s recommendation). Follow basecoat manufacturer’s recommendation for recoat intervals.

MIXING DIRECTIONS:
Mix 4 parts #555 clear with 1 part #551, #552, or #553 activator by volume. Activator selection should be based on the size of the part to be painted and the temperature of both the air and part at time of painting.

SUBSTRATES:
Commercially available acrylic/cab basecoats with a VOC less than 6.6 lbs/gal.
Properly prepared previously painted substrates

CLEAN-UP & STORAGE:
Clean spray equipment immediately after use with Acrylic Lacquer Thinner or Urethane Reducer. Do not leave material in spray gun.

SAFETY INFORMATION - FOR PROFESSIONAL/INDUSTRY USE ONLY:
DANGER: FLAMMABLE! HARMFUL IF INHALED - MAY AFFECT THE BRAIN OR NERVOUS SYSTEM, CAUSING DIZZINESS, HEADACHE OR NAUSEA. IRRITATES EYES, SKIN AND RESPIRATORY TRACT. Contents are FLAMMABLE. Vapors may cause flash fires. Keep away from heat, sparks, and open flame. During use and until all vapors are gone: Keep area ventilated - Do not smoke - Extinguish all flames, pilot lights, and heaters - Turn off stoves, electric tools and appliances, and any other sources of ignition. SEE CONTENTS STATEMENT ELSEWHERE ON LABEL. VAPOR HARMFUL. Use only with adequate ventilation. This product must be used with an appropriate catalyst. Follow the respirator requirement and instructions on the catalyst. Avoid contact with eyes and skin. Wash hands after using. Keep container closed when not in use. Do not transfer contents to other containers for storage. FIRST AID: If INHALED: If affected, remove from exposure. Restore breathing, Keep warm and quiet. If on SKIN: Wash affected area thoroughly with soap and water. Remove contaminated clothing. Launder before re-use. If in EYES: Flush eyes with large amounts of water for 15 minutes. Get medical attention. If SWALLOWED: Get medical attentionimmediately. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Contains solvents which can cause permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents can be harmful or fatal. This product must be mixed with other components before use. Before opening the packages,
READ AND FOLLOW WARNING LABELS ON ALL COMPONENTS. DO NOT TAKE INTERNALLY. KEEP OUT OF THE REACH OF CHILDREN. FOR PROFESSIONAL USE ONLY. SEE MATERIAL SAFETY DATA SHEET. Prop 65 Statement: WARNING: This product contains a chemical known to the state of California to cause cancer, birth defects or other reproductive harm. Contents: acrylic polyol/polymer/resin (trade secret), ACETONE 67-64-1, XYLENES 1330-20-7, n-BUTYL ACETATE 123-86-4, methyl n-amyl ketone 110-43-0, ETHYL BENZENE 100-41-4, STYRENE MONOMER 100-42-5, 2-(2-hydroxy-3,5-di-(tert)-amylphenyl) benzotriazole 25973-55-1. Manufacturer’s Exclusive Limited Warranty: For Industrial use only by professional, trained personal using proper safety protective equipment. Not for sale to, or use by, the general public. Manufacturer warrants that its products are free from defect in material and workmanship at the time of sale. In the event that any product is proved by objective testing and analysis to have been defective at the time of sale, upon the return of the defective product, the manufacturer shall replace the product at no cost, excluding the shipping costs, as the exclusive remedy. This warranty does not cover damage caused by accident, misuse, improper application, improper combination of products or tampering. ALL IMPLIED WARRANTIES WHETHER IT BE OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR PURPOSE ARE EXCLUDED. THIS WARRANTY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES.
KEEP OUT OF REACH OF CHILDREN. REFER TO MATERIAL SAFETY DATA SHEET. EMERGENCY MEDICAL & SPILL CONTROL CHEMTREC (800) 424-9300
Made in the USA for ABI/Autobody Brands International a division of IAMG/International Autobody Marketing Group, Scottsdale, AZ 85257 www.autobodybrands.com

Call 1-87REFINISH (1-877-334-6474) to
find your local Advantage Refinish Products
supplier. Or visit our website:
www.autobodybrands.com